Electronic Buzz Wire Game Circuit

 Introduction:

                             This Circuit is the One the Game in Electronics. This was named “Buzz Wire Game”. This is Favorite Game of the Children. This is the Cheap and Easiest Project Made in House. So let we see How to make this Project. This Project Cost is Less than or Equal to the 100 Rupees. It is Very Easy to make and work.

Connections:

                          First of all, take the PVC or Wooden Sheet with Four Corner Bush. Then take two Scales and Drill the Hole on the Scale’s Upper and Lower End. Fit the L-Clamp on the Lower End of the two Scales. Drill the Holes on Two Ends of the Wooden Sheet and Fit the Scales on those Holes. Take Some Length of Thicker Copper Wire and Make Custom Zig-Zag Shape On it. Fit the “Thicker Copper Wire with Sleeves on end” in the Holes on the Upper Side of the Scale. Then make Long Rounded Hook using Sub Copper Wire and Put that inside of the Copper Rails. Solder one Wire on the Copper Rail (Zigzag Copper) and Solder the Wire’s another End on the +ve of the Buzzer. Then Take One LED with the 1K Resistor and Solder the LED’s +ve Wire to the 2nd Scale’s Top Side. Take One Long Wire and Solder that Wire’s One End to the Long Rounded Hook’s End. Then Connect the Another End of the Wire to the Switch’s 1st Pin and +ve of the Battery Connected to the Switch’s 2nd Pin. When the LED was Blinking, Thus we are Won. If the Buzzer was Alarming, We are Loss. Thus the Game Was Working in Continuity Tester Method.

Note:

         If you haven’t Any Wooden or PVC sheets, You can make it with Cardboard and Waste Boxes. You Can Get Copper Wires from the Electrical Shops.

Circuit Diagram:

Working:

                 This Project is working in the Method of the Continuity Tester Project in our Blog. First of all, we switched on the Circuit. Then Take the Copper Ring and Move it to Another End. If you touch the Thicker Copper Wire, Then the Buzzer was Alarming. This Buzzer Sound Means, You were Loss.

Part List:

1)PVC or Wooden Sheet =1

2)Buzzer =1

3)LED with Resistor =1

4)9 Volt Battery with Strip =1

5)Copper Wire =1

6) Switch =1

7) Glue

8) Some Wires

Click Here to See the YouTube Video for this Article:

By,

G.Guruvel Sarveshwar,

EEE Dept.